Differences

This shows you the differences between two versions of the page.

--- projects:3d_printer_info [2018-06-15 05:38]
trinitor
+++ projects:3d_printer_info [2018-06-22 18:59]
trinitor [Mods]
@@ Line 53: / Line 53: @@
   * Select PLA
+=== Plugin ===
+install
+  * Auto Orientation
+  * OctoPrint connection
 ===== Mods =====
-placeholder
+  * [[https://www.thingiverse.com/thing:2943947|Filament Guide Snap In]]
+  * [[https://www.thingiverse.com/thing:2894097|Filament Guide]]
+===== Tests =====
+  * [[https://www.thingiverse.com/thing:763622|3DBenchy - The jolly 3D printing torture-test]]
+  * [[https://www.thingiverse.com/thing:1278865|XYZ 20mm Calibration Cube]]
 ===== Publicly available models =====
@@ Line 84: / Line 92: @@
 ===== OctoPrint =====
-[[https://octoprint.org]]
+==== Installation ====
+  * download [[https://octoprint.org]]
+  * write image to SD card
+  * edit octopi-wpa-supplicant.txt and enter WiFi information
+  * connect camera to RPi
+  * connect Ender 3 to RPi with micro USB cable
+  * boot RPI
+  * ssh IP
+    * user: pi, password raspberry
+    * passwd
+  * http://ip
+    * setup wizard
+      * Width = 220 mm, Depth = 220 mm, Height = 250mm
+      * enable access control
+      * enable blocklists
+    * Serial Port = Auto
+    * Baudrate = Auto
+==== Cura Integration ====
+  * Get API key in the Ocroprint webinterface
+    * Settings -> API
+  * Connect Cura
+    * Preferences -> Printers -> select printer -> Connect OctoPrint
+    * Enter API key