projects:3d_printer_info
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
projects:3d_printer_info [2018-06-16 11:16] trinitor [Publicly available models] |
projects:3d_printer_info [2018-07-23 15:28] (current) n00ne [3D Printer Information] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== 3D Printer Information ====== | ====== 3D Printer Information ====== | ||
| + | {{: | ||
| ===== Our Hardware ===== | ===== Our Hardware ===== | ||
| We went for a cheaper printer to start with. \\ | We went for a cheaper printer to start with. \\ | ||
| Line 53: | Line 53: | ||
| * Select PLA | * Select PLA | ||
| + | === Plugin === | ||
| + | install | ||
| + | * Auto Orientation | ||
| + | * OctoPrint connection | ||
| ===== Mods ===== | ===== Mods ===== | ||
| - | placeholder | + | * [[https:// |
| + | * [[https:// | ||
| + | * [[https:// | ||
| Line 88: | Line 93: | ||
| ===== OctoPrint ===== | ===== OctoPrint ===== | ||
| - | [[https:// | + | ==== Installation ==== |
| + | * download | ||
| + | * write image to SD card | ||
| + | * edit octopi-wpa-supplicant.txt and enter WiFi information | ||
| + | * connect camera to RPi | ||
| + | * connect Ender 3 to RPi with micro USB cable | ||
| + | * boot RPI | ||
| + | * ssh IP | ||
| + | * user: pi, password raspberry | ||
| + | * passwd | ||
| + | * http://ip | ||
| + | * setup wizard | ||
| + | * Width = 220 mm, Depth = 220 mm, Height = 250mm | ||
| + | * enable access control | ||
| + | * enable blocklists | ||
| + | * Serial Port = Auto | ||
| + | * Baudrate = Auto | ||
| + | |||
| + | ==== Cura Integration ==== | ||
| + | * Get API key in the Ocroprint webinterface | ||
| + | * Settings -> API | ||
| + | * Connect Cura | ||
| + | * Preferences -> Printers -> select printer -> Connect OctoPrint | ||
| + | * Enter API key | ||
projects/3d_printer_info.1529147794.txt.gz · Last modified: 2018-06-16 11:16 by trinitor
Page Tools
